When Should You Replace Your Car’s Accelerator Rubber Pad

Your car’s accelerator rubber pad might seem like a small part of your car, but it is crucial that you change it when needed. Small issues can turn into large ones if you are not careful, but luckily you do not have to wonder when you need to replace parts of your car and get new Mercedes Benz body parts. Here are signs you need to replace the car’s accelerator rubber pad and how you can replace it.

The Signs

If your car’s accelerator rubber pad needs to be replaced, there are a few signs that you can look for. For instance, if it looks a bit crusty, that might be from use over time, especially if you put a lot of pressure on it or use dirty shoes when you drive. Another sign is that it could be brittle, which would have a similar look. If you see if there are cracks or tears in the rubber pad of your car’s accelerator, then you should probably get a new one. We recommend that you use the same brand of replacement for your car – for instance, get Mercedes Benz body parts if you own a Mercedes Benz car.

Installing Accelerator Rubber Pads

If you want to replace the rubber pads because they are old or you just want a nice and stylish one, there are many ways that you can do it on your own. The first thing that you should do is to be safe – activate your vehicle’s emergency brake so it will not roll while you are changing the rubber pad. To get the bolts under the accelerator, remove the floor mat on the driver’s side.

Use your fingers to pry off the factory brake pedal cover. Slide the fingers under the pedal cover’s top portion then lift it upwards – once you remove the top portion, the cover should easily slide off. Insert the screwdriver’s flat end in the slit that is between the right side of the metal pedal and the cover to take out the clutch pedal cover. To pop it off the pedal cover, twist it.

Put the punch in the pedal bracket’s pin area that connects the car’s pedal to its assembly. Hammer the pin until it nearly fully comes out. From the metal assembly, remove the factory pin. Use a degreaser and clean shop towel to clean the pedal’s metal portions to remove grime and dust. Put the pin in the back of the car’s pedal through the mounting hole to install the new accelerator pedal. Use the same way you removed the accelerator assembly to replace it. Tighten 13 mm nuts in the car’s floor then reattach the accelerator retainer and cable.

Finally, boil the new clutch pedal covers and brake in a small saucepan with 4 cups of water on the stove for about 2-3 minutes, then turn off the heat then take it off the burner. Use tongs to remove the hot pedals then dry them on a dry clean cloth then let them cool before touching them for around 1-2 minutes. Stretch the pedal cover’s rubber portion over the brake pedals top part then make your way down then repeat it for the pedal cover of the clutch.

If you want to replace your accelerator’s brake pads, follow the advice above to have a smooth replacement.

When it comes to Mercedes Benz body parts, do not get them from just any supplier. Only get from reputable ones such as Adsit, the #1 Mercedes parts supplier today.